XT-R1型阳离子快裂沥青乳化剂

XT-R1型阳离子快裂沥青乳化剂

一、产品性能特点
     
该乳化剂具有用量少,乳化能力强,综合性价比高的特点。使用时经过调酸后,能很好的乳化各种道路石油沥青。在公路工程中用于沥青路面的表面处治、贯入式路面、碎石封层、粘层及下封层。该沥青乳化剂生产的乳化沥青各项性能指标符合JTG F40-2004的 PC-1、PC-3标准。

二、主要技术指标
   1.
活性物含量:  ≥95%
   2.溶解度:     1:100的酸性水完全溶解
   3.PH值:       8-10
   4.外观:       棕红色液体

三、使用说明
1.
各种材料占乳化沥青的比例  

   道路石油沥青    不小于50%
   乳化剂(实物) 0.3%~0.5%
   水                   至100%
   PH值               用盐酸调至1.5-2.5
2.乳化工艺:
   沥青加热至140-145
,乳化剂水溶液加热至50-55,用盐酸调乳液PH值到1.5-2.5(经过搅拌混合后再测PH值,此时比较准确)之间,即可生产乳化沥青。

四、包装
  XT-R1型阳离子快裂沥青乳化剂
采用180kg铁桶包装。
五、贮存
    
本品放在阴凉通风处,贮存期三年以上。注意防止进入眼睛,和接触皮肤。如发生请及时用流动清水冲洗。    
六、备注
    
本产品在常温下为液态,在气温低于15的情况下,本产品的部分为半固态,但不影响产品性能,使用前对乳化剂稍加热即变液态,搅拌均匀后即可使用。

I、Product property features
The emulsifier has features of less consumption but strong emulsification and the high comprehensive cost effective. In the use, the adjustment shall be done to correct acidity to emulsify different kinds of petroleum asphalt for road construction. The emulsified asphalt produced by using emulsifier is used in surface treatment, penetration road surface, macadam seal, tack coat and subbase seal for road construction. The produced emulsion asphalt’s property indicators meet PC-1, PC-3 standards of JTG F40-2004
II、Major technical indicators
1.Active matter content:   ≥95%
2.DisDissolubility: Complete1y dissolved in 1:100 acidic water
3.PH Value:8-10
4.Appearance:Brownish red liquid
III、Operation Instruction
   1.Material content ratio in emulsified asphalt
   Petroleum asphalt for road not less than 50% 
   Emulsifier (substance )0.3%~ 0.5%
   Water up to 100%
   PH Value Adjusted by hydrochloric acid to1.5-2.5
   2. Emulsification process:
   Asphalt is heated to 140-145
,and the emulsifier water solution is heated to 50-55. And the emulsion is adjusted by hydrochloric acid to PH 1.5-2.5 (the PH value shall be tested after mixing to ensure accurate result), thus the emulsified asphalt is produced.
IV、Packaging,storage and other precautions.

Model XT-R1cationic fast breaking asphalt emulsifier is packaged in 180kg plastic barrel
This product should be stored in cool and ventilated warehouse for 3 years custody.
Take caution not to get it in touch with eyes or skin wash by flowing water in case of unexpected touch.

V, storage
   This product is placed in a cool and ventilated place, long-term storage.

VINote

This product is a liquid at room temperature, when the temperature is below 15  condition, this part of the product is semi-solid, but does not affect the performance of the product, before use of emulsifier is changed slightly heatedliquid, stir can use.

 


0.00
0.00
  

一、产品性能特点
     
该乳化剂具有用量少,乳化能力强,综合性价比高的特点。使用时经过调酸后,能很好的乳化各种道路石油沥青。在公路工程中用于沥青路面的表面处治、贯入式路面、碎石封层、粘层及下封层。该沥青乳化剂生产的乳化沥青各项性能指标符合JTG F40-2004的 PC-1、PC-3标准。

二、主要技术指标
   1.
活性物含量:  ≥95%
   2.溶解度:     1:100的酸性水完全溶解
   3.PH值:       8-10
   4.外观:       棕红色液体

三、使用说明
1.
各种材料占乳化沥青的比例  

   道路石油沥青    不小于50%
   乳化剂(实物) 0.3%~0.5%
   水                   至100%
   PH值               用盐酸调至1.5-2.5
2.乳化工艺:
   沥青加热至140-145
,乳化剂水溶液加热至50-55,用盐酸调乳液PH值到1.5-2.5(经过搅拌混合后再测PH值,此时比较准确)之间,即可生产乳化沥青。

四、包装
  XT-R1型阳离子快裂沥青乳化剂
采用180kg铁桶包装。
五、贮存
    
本品放在阴凉通风处,贮存期三年以上。注意防止进入眼睛,和接触皮肤。如发生请及时用流动清水冲洗。    
六、备注
    
本产品在常温下为液态,在气温低于15的情况下,本产品的部分为半固态,但不影响产品性能,使用前对乳化剂稍加热即变液态,搅拌均匀后即可使用。

I、Product property features
The emulsifier has features of less consumption but strong emulsification and the high comprehensive cost effective. In the use, the adjustment shall be done to correct acidity to emulsify different kinds of petroleum asphalt for road construction. The emulsified asphalt produced by using emulsifier is used in surface treatment, penetration road surface, macadam seal, tack coat and subbase seal for road construction. The produced emulsion asphalt’s property indicators meet PC-1, PC-3 standards of JTG F40-2004
II、Major technical indicators
1.Active matter content:   ≥95%
2.DisDissolubility: Complete1y dissolved in 1:100 acidic water
3.PH Value:8-10
4.Appearance:Brownish red liquid
III、Operation Instruction
   1.Material content ratio in emulsified asphalt
   Petroleum asphalt for road not less than 50% 
   Emulsifier (substance )0.3%~ 0.5%
   Water up to 100%
   PH Value Adjusted by hydrochloric acid to1.5-2.5
   2. Emulsification process:
   Asphalt is heated to 140-145
,and the emulsifier water solution is heated to 50-55. And the emulsion is adjusted by hydrochloric acid to PH 1.5-2.5 (the PH value shall be tested after mixing to ensure accurate result), thus the emulsified asphalt is produced.
IV、Packaging,storage and other precautions.

Model XT-R1cationic fast breaking asphalt emulsifier is packaged in 180kg plastic barrel
This product should be stored in cool and ventilated warehouse for 3 years custody.
Take caution not to get it in touch with eyes or skin wash by flowing water in case of unexpected touch.

V, storage
   This product is placed in a cool and ventilated place, long-term storage.

VINote

This product is a liquid at room temperature, when the temperature is below 15  condition, this part of the product is semi-solid, but does not affect the performance of the product, before use of emulsifier is changed slightly heatedliquid, stir can use.